POWERSTOPP

Standard on 1 1/4" - 8" valves
2" - 6" design torque, maximum 600 ft.lbs.
8" design torque, maximum 1,750 ft.lbs.

Stem Bearings

These bearings are produced from an electrically conductive material that provides a safety grounded stem (UL Required) to eliminate static build-up and potential arcing.

Seat Seals

The special 25% carbonized PTFE (TeflonÔ ) (G-453) seals tightly, yet allows easy, low-torque, quarter-turn operation.

Stainless Labels

Every label is permanently stamped, color coded with traceable serial numbers for each valve.
-Black 285 MOP
-Red 500 MOP
-Blue 740 MOP

 

Carbon Steel Ball Valve Information

 

SEAT QUALITY FEATURES

• Do not absorb water, and does not expand
• Chemical resistent
• High friction charateristics
• Good temperature stability
• Tested and approved up to 250º C

The base material:	PTFE Powder
Type of material:	G453
Particle size:	60 micron
Part. Size of filler:	40 micron
Type of filler:	Carbon
Mix:	PTFE +20% carbon
Tolerance of content:	+ - 5%

 

 

 

BROEN BALLOMAX^® Components and Material

 

Components and Material

1. Powerstopp (Heat Treated Steel)	10. Carbon Steel Pipe body
2. Stem Seals (Buna N O-Rings)	11. Stainless Steel Ball
3. Lock Wing Flange	12. Seat Ring
4. Stainless Steel Stamped Label	13. Seat O-Ring (Buna N O-Rings)
5. 2" Square Nut w/Lock Wing	14. Seat Support Ring
6. Weather Seal (Buna N Gasket)	15. Stainless Steel Belleville Spring
7. Steel Travel Stop Pin	16. Protective End Cap
8. Stem	17. Body End Connections
9. Body Stem Gasket	18. Stem Bearings (Lead Coated)